AlexMos - BaseCam SimpleBGC 32-bit

BaseCam SimpleBGC can be used to controll brushless gimbals. Motor controllers are already included.

Attribute	Value
Board Version	3.0
Used Firmware	2.50 b2
Control Interface	Java application (works with OSX)
Characteristic	Hard to understand and apply tuning otpions Auto tuning was not working Shows continous drifts over time Bluetooth not working for me (pairing works, serial speed matches, modules work with other applications)

Upgrade fails, then BaseCam SimpleBGC is bricked. USB connection no more possinble

Solder and Set Jumper at BaseCam SimpleBGC board, where you see the label "FLASH"
Power the Board by USB
Start GUI and go to Upgrade -> Manual
Select the "recovery" File
Select board version with "Virtual Com Port"
Select connection device address, but DON'T click connect
Press flash

Camera IMU seems not to be working after upgrade.
Solution: Calibrate Camera IMU